SEM 39143 Trim Black Spray Aerosol (2)

15 Oz Aerosol Satin Gloss Level Matches factory finish on many automotive exterior trim components. No primer needed for adhesion. SEM Trim Paint Surface Preparation: Wash the part thoroughly with 39362 SEM Soap. Clean with good quality Grease and Wax remover such as SEM 38373. Sand with 400 grit sandpaper and reclean with G&W remover. Mask off all areas not to be coated to protect from overspray. Apply light mist coats evenly allowing 5-10 minutes between coats. Several thin coats are better than 1 heavy coat. Salesman Note: Don’t rush to install the part. Trim Paint adhesion improves with time. Full hardness and maximum adhesion should be obtained in about 48 hours. Warning: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm.